Painful stick

napsgearhttps://ugloz.is/ domestic-supplypuritysourcelabsYOURMUSCLESHOPUGFREAK

LeatherHead

New member
Gold Member
So i normally pin my Delts or thighs with cyp, a little soreness not uncommon. But last week i hit my delt with some new test E, and i still feel like i took a hundred mile an hour fast ball to the shoulder. Haven't really had pain like this from a stick. Now when i aspirated i pulled a little hard to where i had an air bubble pull up. Is it possible to over aspirate? Or is it just the test that's causing it? It hurts to touch my shoulder or even just move my arm.

Sent from my DROID RAZR using Tapatalk 2
 
sounds like it might just be the test bro, especially if its new test you havent done before, thats my guess anyhow
 
That's good to know. I was starting to get concerned. Thanks bro

Sent from my DROID RAZR using Tapatalk 2
 
Probably the Test like Presser said. Its got a higher ba content then your last stuff.
 
I'd try to cut it with another oil that doesnt hurt so much.

- - - Updated - - -

BTW Answer your phone LH.
 
I'd try to cut it with another oil that doesnt hurt so much.

- - - Updated - - -

BTW Answer your phone LH.

I'll call you later. Right now text easier than talk, so I can keep making money. ;)

Sent from my DROID RAZR using Tapatalk 2
 
All depends on who and how they brewed/mixed it up, but most UGL will cut corners and just use basic mix or less, and in that case they are cramming more test than the solution can hold and it's painful. You can dilute it down with another oil of much lesser mg/ml. Or just get a filtered USP oil, GSO or Cotton and dilute it down to 300mg/ml, or just suck it up.
 
I've had 500mg not hurt one bit and the last one of 350 hurt like a sob. but likely it is the test man, that shit hurts.

I made it through by filling a syringe the night before and pinning the next day and that helped a lot.
 
I've had 500mg not hurt one bit and the last one of 350 hurt like a sob. but likely it is the test man, that shit hurts.

I made it through by filling a syringe the night before and pinning the next day and that helped a lot.
Yep, all depends on how's it's mixed up.
 
So i normally pin my Delts or thighs with cyp, a little soreness not uncommon. But last week i hit my delt with some new test E, and i still feel like i took a hundred mile an hour fast ball to the shoulder. Haven't really had pain like this from a stick. Now when i aspirated i pulled a little hard to where i had an air bubble pull up. Is it possible to over aspirate? Or is it just the test that's causing it? It hurts to touch my shoulder or even just move my arm.

Sent from my DROID RAZR using Tapatalk 2

you arent pulling air in bro, unless there's a leak between the syringe and the needle(you arent going to pull it from the muscle).. it's merely a vacuum you are creating.. Presser is right in saying it's probably the test... I've seen enanth that has unreacted acid in the 'waxy' chunk of enanthate. This can cause severe pain after injection, especially when the enanthate is made at higher mg levels(lower mg enanthate=lower mg of impurities)
 
you said it was enatate that test tends to hurt more than others ive noticed.i always get sore when i do the en.but when i do cyp it dont hurt as much.so yeah its just the test bro.....
 
What if i pulled my tren into the same pin and pushed the test and tren at the same time? Think that would help?

Sent from my DROID RAZR using Tapatalk 2
 
What if i pulled my tren into the same pin and pushed the test and tren at the same time? Think that would help?

Sent from my DROID RAZR using Tapatalk 2

Yes But I'd split it into two separate shots. IE if you're doing one cc a week of test split the test into 1/2 cc shots combined with a cc of tren for a total of 1.5 cc's in eash shot. The smaller amount of ba in each shot will allow to heal faster and have lots less pain. Let the oils combine and hit them in a freshly trained muscle group. Should help a lot.
 
Back
Top