Recent content by bushidobadboy

Also, if you vent with a hypo needle, even at lower temps (250 say), the needle will soak up heat very effectively and damage the bung, causing it to no longer 'close up' properly. At least, this is what happened to me on two occasions... bushboy

Haha, yeah sorry to 'geek out' there but hey - part of me IS a geek! I just gotta know... I really like the marble/bearing idea and will nick it, thanks. I still dont quite see how you do it (mix powders I mean). I tried mixing the powder and BA/BB before adding the oil (and used a warm water...

Thanks for the reply Brew. I hear you on the heat issue / ideas, might have to give them a go as most of my brews keep crashing LOL! Have to respectfully disagree with you on the boiling point thing though... Unless my chemistry lecturer is completely wrong, water reaches boiling point at 100...

Um, Brew I have a couple of questions bro... You say that 'water begins to boil at 212'. Water ONLY boils at that temp (at sea level, less at altitude). Just 'cos you turn up the setting on your stove, it does not increase the temp of the water... The water remains at boiling point until all of...

All you do is keep the baked vial in the oven until it has cooled enough to handle it... Aint gonna be no airborne bacteria in that oven if its just been on 250 degrees for 30 minutes... So leave it (with the door closed or slightly cracked - to speed up the cooling process) for 30 -60...

Hey bro Two questions 1. how long did you bake your gear for? 2. how many filters did you need to create your product? The answer to 1 is relevant 'cos my last brew of masteron was time dependant - ie I left it in for 20 mins and there was some powder in the bottom of the mixing vial. After...

My oven is gas so it has no temp gauge. I set it on level '5' and measured it with a digital therm. @ 200 degrees F. Left it in for 45 minutes. As I said in my earlier post, my hypo melted all over my bung. These days I just remove the bung altogether and re-crimp it on once the vial has...

Somebody (who it has to be said knows a thing or two about brewing - he runs a UG lab) said to me that methenolone ace is unsuitable for conversion into injectable format. He did not explain why, so I'm askin'... Is it unsuitable simply because it requires a high conc. of solvents? If this is...

I made some @ 150mg /ml from a 'recipe' someone gave me. It crashed like a mofo, so I increased the BA and BB. To be honest I'm not sure what % they are at now, but I guess 6% and 20%. There is little or no pain from the shot though. Which is nice :) bushboy

Hey bro Coincidentally, I made up 50ml of masteron @ 100mg/ml just last night. I used 2% BA and 20 %BB. At first it didn't want to 'take'. so I just left it in the oven a little longer and BINGO, smooth as a prom-queens' thighs - but cleaner! bushboy

So vent it and bake it in the oven and you can be sure that it is 'good to go'. Don't do what I did and vent with a hypo. The plastic will melt all over the top of your vial - Doh. :o bushboy