I found this recipe:
Give this a try. 50 ml @ 200 mg/ml
supplies
10g 1-test cyp powder
10cc sryinges
20g needels
25g needles
.22 or .45 whatmans
BA
BB
Cottenseed oil or GSO
steirile, sealed 50ml vial
unsealed 50ml vial
rubber stoppers
funnel
glass rod to stir.
1. put 50cc of water in the unsealed vial, and mark where that line was with a marker, and set both vials side by side and mark on the sterile vial.
2. clean out unsealed vial with BA and let dry
3. add 10g 1-test cyp powder to unsealed vial
4. Add 12mls (NOT %) benzyl benzoate to powder
5. Add 3mls benzyl alcohol
4. use glass rod to stir solution, while the powder starts to dissolve.
5. put a pot of water on stove, and bring to a boil
6, add cottonseed Or GSO ,until it is about 3-4 ccs (estimate) shy of the marker line.
6. put rubber stopper on unsealed vial, and put a 25g needle through it.
7. put vial in boiling water until the solution is no longer cloudy.
8. clean off sterile vial stopper with alcohol wipe, and put 25 g needle through it.
9. useing filters, and 10cc sryinges, start to filter the solution into the sterile vial.
10. when all the solution is in the vial, filter more cottenseed oil though the SAME Filter, up to the marker line on vial. reason for this is to push through any 1-test cyp left in the filter.
11. bake solution, with 25g needle in stopper, at 250 degrees for 45 minutes.
Give this a try. 50 ml @ 200 mg/ml
supplies
10g 1-test cyp powder
10cc sryinges
20g needels
25g needles
.22 or .45 whatmans
BA
BB
Cottenseed oil or GSO
steirile, sealed 50ml vial
unsealed 50ml vial
rubber stoppers
funnel
glass rod to stir.
1. put 50cc of water in the unsealed vial, and mark where that line was with a marker, and set both vials side by side and mark on the sterile vial.
2. clean out unsealed vial with BA and let dry
3. add 10g 1-test cyp powder to unsealed vial
4. Add 12mls (NOT %) benzyl benzoate to powder
5. Add 3mls benzyl alcohol
4. use glass rod to stir solution, while the powder starts to dissolve.
5. put a pot of water on stove, and bring to a boil
6, add cottonseed Or GSO ,until it is about 3-4 ccs (estimate) shy of the marker line.
6. put rubber stopper on unsealed vial, and put a 25g needle through it.
7. put vial in boiling water until the solution is no longer cloudy.
8. clean off sterile vial stopper with alcohol wipe, and put 25 g needle through it.
9. useing filters, and 10cc sryinges, start to filter the solution into the sterile vial.
10. when all the solution is in the vial, filter more cottenseed oil though the SAME Filter, up to the marker line on vial. reason for this is to push through any 1-test cyp left in the filter.
11. bake solution, with 25g needle in stopper, at 250 degrees for 45 minutes.