failded test a and e recipe

[Joshe97]

10 grams of each brewed separately i dont care about the dosage per ml i just need it to suspend so its injectable

yesterday i tried this recipe and twice it would not suspend after being in 200F+ heat over 30 min i sorta forgot about it after checking on constantly for the first few minutes

Test e 200mg/ml 10g=50ml

1%BA=.5ml
20%BB=10ml
MCT=29.5ml

the first time i added 30 extra ml of mct oil to help it suspend the 2nd time i just stuck to the recipe

in the past i used this recipe without a problem but my jar broke so here i am. last time i made this 50 gram dosage i really didnt even need heat everything went perfect and i thought this shit was easy

Test e 200mg/ml 50g=250ml
1%BA=2.5ml
20%BB=50ml

MCT= 147.5ml


Both raws are from same source just purchased at different times, however this is my first time trying with test ace. i will say the raws seem different in texture in the past they were more fine like powder this time theyre more crystalized like salt they do smell the same for whatever thats worth

Test a 100mg/ml 10g=100ml

1%BA=1 ml

20%BB=20ml


MCT= 59ml



if anyone could help or give a recipe that just works for test e and ace.

if you want picture of my failure ill upload them so you can laugh at me but its basically just cloudy oil and the test e with an extra 30 ml of mct is a crystalized mess at the bottom not cloudy

 

[Presser]

testosterone enanthate should be powder like. not salty like which is how propionate is. I am unfamiliar with testosterone acetate though.

 

[CRC1276]

Test e should not be an issue honestly. And 200 degrees is way too hot for both. Test e melts when it’s above 80 outside really. The fact that you are getting a crystallized mess is what would concern me. I would suspect it being another compound at this point. And 1%BA and 20% BB is plenty for both. You should be able to get away with 18. Even test ace should really not be hard to brew up. And yeah test e is white powder and in the summer months should honestly come to you almost liquid already from the heat. It has a very low melting point. Test ace is more grainy and has higher melting point. But I have used same percentages for both for years and never had issues. I would contact your source or use another or maybe even send some samples out for testing at this point.


Sent from my iPhone using Tapatalk

 

[CRC1276]

Also when brewing only use enough heat to melt the raw into solution so it stays. Never overheat anything. But overheating is not a reason for crystallized gear.


Sent from my iPhone using Tapatalk

 

[Joshe97]

i had it in like a bath of boiling water the first time instead of direct heat after it was in contact with heat it suspended