highest concentrations for EQ, deca, npp, tpp, etc.

[detone01]

Im looking to start making my gear as highly concentrated as possible without substantial increases in injection pain or possible crashing even with EO and 20+%BB. This is what I am thinking:
TEST E/C - 330 - 400
EQ - 400
Deca - 300-400
test phenylprop - 200
npp - 200
Any experiences with these concentrations? if so, what were you ratios?
thanks.

 

[Presser]

ill bump this bro as i have no idea myself

 

[detone01]

im sure if i use EO as the primary carrier i can hold tpp/npp at those concentrations. Im not worried about deca and eq at 300+ bc of the super low melting points. but test above 300 im not too sure and just cause the eq and deca would hold above 300, it might hurt like shit.

 

[FIREINSIDE]

I have made test-e @ 500mg and a eq blend 200 eq prop and 400mg undec for a total of 600mg/50ml jugg 3.5%ba w/20%bb and EO. Both were pain free and smooth although did get a mild case of test flu. Also made a 200mg prop and injected into my pecs and had no pain at all! One of my props ended up crashing though I think it was cuz it was a 50ml jugg!?
This was like in 06-07 back in the good ol' days!:thumbsup:

 

[mrvtwin80]

im sure if i use EO as the primary carrier i can hold tpp/npp at those concentrations. Im not worried about deca and eq at 300+ bc of the super low melting points. but test above 300 im not too sure and just cause the eq and deca would hold above 300, it might hurt like shit.

I just made some Cyp 300, it's about a week old and holding fine so far. I don't know about the pain factor because I have not tried it yet.I used a 50-50 mix of EO and grape seed oil and I'm anxious to try it unfortunately the next cycle will be short esther's.