Got myself some labmax test tubes to test some of the gear I'm currently running. Often people say "most anavar is faked with winny etc.." or "half of the masteron out there is just test prop". I'm sure you've heard it. I wanted to end the speculation and get peace of mind at the same time. I never truly doubted PSL, but a confirmation is never a bad thing. To sum up the tests, I am happy to say for myself and othersm that both products are 100% GOOD TO GO. You will see in the pictures.
First off here's a link to the LabMax Steroid Identification Color Chart use it to compare with my results.
First test: Masteron prop
Results were observed and captured within a minute of administering to the test vials. Vial "A" should turn bright green, and vial "B" should turn yellow orange.
Under PROPER uv lighting, the solution should show orange in color. I bought my UV light directly from the labmax website so it's the proper wavelength. It was near impossible for me to get a good picture of the orange color because of the strong "glare" from the uv light. It was very easy to see in person. I'm not sure if these pictures are worth showing, but either way maybe someone can see the orange. I could see it in person but the camera wouldn't pick it up with all the light. I tried different lighting/angles but no luck.
Anavar next!
- - - Updated - - -
Second test: oxandrolone (anavar)
Ok so with the anavar I put in 1/8th of a 10mg tab which is what they tell you to do in the instructions. It works best with 1-3mg so I used my pill cutter and cut the tab into 1/4ths then shaved off about half. Then i ground it up and funneled it into the tube. The directions say give it 15 mins to react before observing results.
After 15mins the solution should be a yellow-green and match the color dash on the test tube. If it were winstrol (stanozolol) the solution would be olive green and match the stanozolol color dash. If it were dianabol it would instantly turn the solution dark brown.
Results after 15mins:
As you can see both products are GOOD TO GO! Thank you PSL!
First off here's a link to the LabMax Steroid Identification Color Chart use it to compare with my results.
First test: Masteron prop
Results were observed and captured within a minute of administering to the test vials. Vial "A" should turn bright green, and vial "B" should turn yellow orange.
Under PROPER uv lighting, the solution should show orange in color. I bought my UV light directly from the labmax website so it's the proper wavelength. It was near impossible for me to get a good picture of the orange color because of the strong "glare" from the uv light. It was very easy to see in person. I'm not sure if these pictures are worth showing, but either way maybe someone can see the orange. I could see it in person but the camera wouldn't pick it up with all the light. I tried different lighting/angles but no luck.
Anavar next!
- - - Updated - - -
Second test: oxandrolone (anavar)
Ok so with the anavar I put in 1/8th of a 10mg tab which is what they tell you to do in the instructions. It works best with 1-3mg so I used my pill cutter and cut the tab into 1/4ths then shaved off about half. Then i ground it up and funneled it into the tube. The directions say give it 15 mins to react before observing results.
After 15mins the solution should be a yellow-green and match the color dash on the test tube. If it were winstrol (stanozolol) the solution would be olive green and match the stanozolol color dash. If it were dianabol it would instantly turn the solution dark brown.
Results after 15mins:
As you can see both products are GOOD TO GO! Thank you PSL!
Simultaneously adding muscle too.
