Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
so it will basically stay suspended in everclear?? You dont need PEG 300, or 600? So if i have the powder and everclear, im good to go?Hell im sleepy. Correct my math if im wrong........but you get the idea.
i tried capping, and it sucks, so im going with the everclear....actually im gonna use graves (190 proof)Heres what I did to get it to suspend.
Take 1gram of Viagra and pour in 19ml of everclear (To get 50mg/ml--20ml by volume).
Put some water in a pot and get it going to a nice boil. Lower the flame or shut it off.
Put the vial containing the everclear/viagra mixture in the pot for three (3) minutes.
make sure water level is adequate-about 3/4 the height of the vial.
After three minutes take the vial out screw or cap it then shake.
Keep your stove flame on enough to keep the water in the pot to a boil or near a boil.
Put the vial back in the Boiling water for another 3 minutes.
Shake again. You should be suspended now. Depending on quality (cut or not) of powder some people add peg300 ( varying amount until desired effect)to the mix but only if suspension fails with the everclear only.
* Note some of the solution will evaporate in the boil so if you need to be dead on accurate you will want to add more everclear or peg to make up for the small amount lost.
Personally I had a solid powder store and Everclear was all I needed.
Good luck any route you go.