Pharm_Fed
MuscleChemistry Registered Member
First off, let me say, I inject slowly, I leave the pin in for 30 seconds after injecting and I don't think I'm going too shallow.
That being said, tonight I hit my delt and after pulling the pin out a LOT of blood came out. I don't really care about that, but my concern is that I lost a good portion of what I injected with the blood when it came out. I aspirated so I know I didn't inject in a vein, may have nicked one though? Usually I have a little blood come out after withdrawing, but never this much. Not sure if I should pin again or just not worry about it.
The consistency of the blood did seem _different_ than normal. A little thinner perhaps. Not sure if that's because of the oil? I used a 1" pin in my delt, I think that should be plenty. What do you guys think about this? Is it most likely just blood near the surface or could the oil have come out with it?
That being said, tonight I hit my delt and after pulling the pin out a LOT of blood came out. I don't really care about that, but my concern is that I lost a good portion of what I injected with the blood when it came out. I aspirated so I know I didn't inject in a vein, may have nicked one though? Usually I have a little blood come out after withdrawing, but never this much. Not sure if I should pin again or just not worry about it.
The consistency of the blood did seem _different_ than normal. A little thinner perhaps. Not sure if that's because of the oil? I used a 1" pin in my delt, I think that should be plenty. What do you guys think about this? Is it most likely just blood near the surface or could the oil have come out with it?