Need help with measurements..

https://ugloz.is/ domestic-supplyUS-PHARMACIES UGFREAKParaPharma

Local124bro

New member
I just got some slin pis from the site sponcer and they are 1ml 29G X 1/2 and say 100 units. Where on that would be 30mcgs? I am wanting to run IGF and am using two pins at 30 mcgs each total of 60 mcgs. Thanks
 
every ten marker is 100mcgs so a whole pin is 1,000mcgs so if the ten marker is 100mcgs the u should be able to figure it out from the inbetween lines easily, did u understand that bro?
 
so in other words every "tick" on your pin is 10mcg so that the actual 10 on the pin is 100mcgs so if you count off 3 tics from the bottom that would be 30.
 
My pins only have 5 spaces between the numbers then it hits 10, 5 more spaces and 20 and so on. So if I count each tick as 10 it would hit 50 mcgs on the 10 unit mark not 100 mcgs. So does 10 units = 100mcgs on a 100 unit / 1 mL pin? Unless my pin is in 20mcg per mark? So if my pin goes by 20 mcg would it hurt to run 40 mcgs per muscle worked like biceps and put 40 in each, total of 80mcgs? I wanted to do 30mcgs but I dont think I can acurately fill it up. This is the first time running IGF , well its not here yet just getting ready.
 
30mcg is a tiney amount - I was supprised. Check where you got your pins - it might
say their capacity and you can break it down from there
 
Back
Top